Jr Xp6102 Transmitter Manual
• INSTRUCTION MANUAL FOR AIRPLANE AND HELICOPTER CAN YOU FEEL IT? XP6102 6-CHANNEL COMPUTER RADIO SYSTEM. • TABLE OF CONTENTS SECTION 1 XP6102 - Introduction. • TABLE OF CONTENTS XP6102 - Introduction. • TABLE OF CONTENTS XP6102 - Introduction. • SECTION 1 XP6102 - Introduction. • A narrow band ceramic filter for high- The R770's Slimline design allows it to fit signal selectivity assists in rejecting cross into most model applications.
Modulations from other common radio frequencies-e.g. R/C transmitters, local paging systems. This receiver features XP6102 - Introduction. • PCM (s) or PPM OUTPUT POWER Approximately 750mw Approximately 750mw CURRENT DRAIN 200mA (70mA with DSC) 200mA (70mA with DSC) POWER SOURCE 1.2Vx Ni-Cd (9.6V) 600mAh 1.2Vx Ni-Cd (9.6V) 600mAh OUTPUT PULSE 1000–2000 (1500 Neutral) 1000–2000 (1500 Neutral) XP6102 - Introduction. • 15 Hours 15 Hours AIRBORNE BATTERY PACK TYPE AIRCRAFT HELICOPTER MODEL NUMBER B1100 B1100 VOLTAGE 4.8 V 4.8 V SIZE (in) (W x L x H) 2.24 x 0.63 x 1.70 2.24 x 0.63 x 1.70 WEIGHT (oz) XP6102 - Introduction. • RED TO NEGATIVE based on 'color-coded' wire leads, as they do not apply in this instance.
Added the FrSky 2.4GHz DHT DIY Module to my old JR XP6102. Simple and easy installation. I also added a DPDT switch and split the signal wire so it goes to both the 72MHz and the 2.4GHz transmitters. The DPDT switches power between the two transmitter boards. So now I can still use my old 72MHz receivers and the latest FrSky receivers.
You must make sure that the center pin of your JR CHARGER PIGTAIL FOR RECEIVER transmitter is always connected to the negative voltage for correct polarity hookup. • ADVANCED DIGITAL TRIMS The XP6102's digital trims also feature the Please also note that unlike conventional Direct Access display function.
While at mechanical trim levers, when the X-6102 the Normal display screen, if a trim lever transmitter is in the off position, no. • ELEV Elevator Channel throttle stick is at less than half throttle. RUDD Rudder Channel This gives easy, accurate idle adjustments GEAR Gear Channel without affecting the high throttle AUX 1 Auxiliary 1 position. Channel (Flap) XP6102 - Airplane Manual. • SECTION 1 XP6102 - Airplane Manual. • (Horizon Service Center). Any transmitter frequency change made by non-certified technician may result in a violation of the FCC rules.
ELEVATOR TENSION RUDDER TENSION SCREW SCREW AILERON TENSION SCREW THROTTLE TENSION SCREW XP6102 - Airplane Manual. • To adjust the stick length, use the approximately one inch longer than 2mm Allen wrench (supplied with your standard. This stick, crafted from bar XP6102 transmitter) to unlock the set stock aluminum, is available at your screw. Turn the wrench counterclockwise local JR dealer. • BASE LOADED ANTENNA An optional base-loaded antenna is the antenna to your XP6102. The Base available for use with the XP6102 Loaded Antenna (JRPA155) is made of a transmitter.
It is considerably shorter than flexible coil and is covered with a soft the standard antenna. Mount the receiver antenna firmly to diagram will assist you in properly the airplane to ensure that it will not mounting your servo. Become entangled in the propeller or control surfaces.
Servo Mounting Tab Screw Rubber Grommet Brass Eyelet XP6102 - Airplane Manual. • GEAR D.S.C. Download driver stick usb itech hockey shield free. - (JRPA132) NEW ABC&W SYSTEM AUX2 SYSTEM AUX1 RUDDER CHARGER - (JRPC221) GEAR RUDD 7 CHANNEL SPCM RECEIVER ELEV ELEVATOR 72 MHz AILE JAPAN REMOTE CONTROL CO., LTD THRO AILERON MADE IN MALAYSIA THROTTLE XP6102 - Airplane Manual. • Should the lithium battery fail, the display battery, contact JR Horizon Service will indicate BACK ERROR.
If this occurs, Center. Due to the possibility of extensive it will be necessary to replace the lithium damage caused by improper removal or battery and reprogram all data. • Select GEAR RIGHT SW FLAP FLAP LVR 3. Use either the Up or Down key to pg 24 scroll through the menu and access the [WING TYPE] Wing applicable function.
FLAPERON Type ELEVON V-TAIL pg 25 XP6102 - Airplane Manual. • MODEL SELECTION The XP6102 system offers memory for ten in conjunction with each model setup.
Completely separate models. Therefore, Another very useful function of the Model it is possible to have a mixture of Selection function is the ability to set helicopter and airplane setups retained one aircraft up several different ways.
• MODEL NAME ENTRY The XP6102 allows an 8-digit name to be input for each of the ten models available. The current model will be displayed in the Normal display. Go to Model Type menu Change selected character Model Number and Type.
• MODEL TYPE SELECTION The XP6102 is capable of performing as a helicopter or airplane radio with full functions for each. Model Type function Model Number and Name Change model type selection Go to Model Copy menu [MODEL TYPE] ALPHA 40. Press the Down key to access the 4. Next, press the Clear key. The current MODEL TYPE function. Model will then be copied to the 7.